Reducer 1/4 to 3/8 Push Connect

Boss recommends using a liquid thread sealant rather than thread tape. Small fragments of thread tape can break off, travel through the airlines and lodge in valves or valve blocks, causing them to stick open or closed. A quality thread sealant seals the threads without shedding debris.

Always cut the airline square with a sharp tube cutter, not side cutters. Push the tube firmly into the fitting until it bottoms out, then pull back gently to seat the collet. Most leaks are caused by angled cuts, scratched tube, or the line not being fully inserted.

You can often reuse fittings and lines if they are in good condition, but if the tube end is scratched, oval or has been repeatedly removed, it is safer to cut back to a fresh section or replace it. Damaged tube ends are a common source of slow leaks.

The REDUCER 1/4 TO 3/8 PUSH CONNECT is designed to connect air lines of different diameters, specifically reducing a 3/8" line to a 1/4" line. This allows for seamless integration within your air suspension system, ensuring efficient air flow and compatibility with various components.

Yes, the REDUCER 1/4 TO 3/8 PUSH CONNECT is engineered to withstand high pressures typically found in air suspension systems. It is important to ensure that the entire system is rated for the pressures you intend to use.

This reducer is specifically designed for use with push-to-connect fittings. Ensure that the fittings you are using are compatible with the 1/4" and 3/8" sizes to maintain a secure and leak-free connection.

Installation is straightforward. Simply cut the air line squarely, ensure it is free of debris, and push it fully into the reducer. For optimal performance, ensure that the connection is secure and leak-free.

This reducer is commonly used in air suspension systems to connect different sizes of air lines, especially in load assist kits. It is ideal for setups where space is limited or where a transition between line sizes is necessary.