Boss recommends using a liquid thread sealant rather than thread tape. Small fragments of thread tape can break off, travel through the airlines and lodge in valves or valve blocks, causing them to stick open or closed. A quality thread sealant seals the threads without shedding debris.

Always cut the airline square with a sharp tube cutter, not side cutters. Push the tube firmly into the fitting until it bottoms out, then pull back gently to seat the collet. Most leaks are caused by angled cuts, scratched tube, or the line not being fully inserted.

You can often reuse fittings and lines if they are in good condition, but if the tube end is scratched, oval or has been repeatedly removed, it is safer to cut back to a fresh section or replace it. Damaged tube ends are a common source of slow leaks.

The MINI REGULATOR WITHOUT GAUGE is designed to provide precise control over air pressure in your air suspension system. It allows for adjustments to be made without the need for a gauge, streamlining your setup and maintaining a clean appearance.

This regulator is designed to integrate seamlessly with Boss airbags and is particularly effective when used with Load Assist kits. It connects via 1/4 NPT fittings, making it compatible with standard air fittings commonly used in air suspension systems.

The MINI REGULATOR WITHOUT GAUGE is ideal for users looking to maintain a compact and efficient air suspension system. It is particularly useful in applications where space is limited, and precise pressure control is required for optimal performance.

While the MINI REGULATOR WITHOUT GAUGE is optimised for use with Boss airbags, it can be used with other brands that accept 1/4 NPT fittings. However, compatibility and performance may vary, so it is recommended to check with the manufacturer of the other components.

The primary difference is the absence of a gauge, which simplifies the design and reduces space requirements. This makes the MINI REGULATOR WITHOUT GAUGE a great choice for those who prefer a clean setup without the additional bulk of a gauge, while still achieving effective air pressure control.

The MINI REGULATOR WITHOUT GAUGE is designed for standard air suspension applications and is not recommended for high-pressure uses beyond its rated specifications. Always ensure that the regulator is used within the manufacturer's guidelines to maintain safety and performance.