Air Speed Controller | 1/4 Push Fit

Boss recommends using a liquid thread sealant rather than thread tape. Small fragments of thread tape can break off, travel through the airlines and lodge in valves or valve blocks, causing them to stick open or closed. A quality thread sealant seals the threads without shedding debris.

Always cut the airline square with a sharp tube cutter, not side cutters. Push the tube firmly into the fitting until it bottoms out, then pull back gently to seat the collet. Most leaks are caused by angled cuts, scratched tube, or the line not being fully inserted.

You can often reuse fittings and lines if they are in good condition, but if the tube end is scratched, oval or has been repeatedly removed, it is safer to cut back to a fresh section or replace it. Damaged tube ends are a common source of slow leaks.

The AIR Speed Controller is designed to regulate the flow of air to your airbags, allowing for precise adjustments in suspension height and ride quality. This can help achieve optimal performance based on load conditions and driving preferences.

Installation of the AIR Speed Controller is straightforward. It features two 1/4" push-fit ends that connect easily to your existing air lines. Ensure that the valve is positioned in a location that is accessible for adjustments.

While the AIR Speed Controller is compatible with most airbag systems that utilise 1/4" push-fit connections, it is always best to verify compatibility with your specific setup to ensure optimal performance.

A flow valve allows for fine-tuning of air pressure in the airbags, which can lead to improved ride comfort and handling. By adjusting the flow rate, you can quickly adapt to varying load conditions without needing to completely re-inflate or deflate the airbags.

Yes, the AIR Speed Controller is suitable for off-road applications. Its adjustable flow feature allows for quick adjustments to accommodate varying terrain and load conditions, enhancing vehicle stability and performance in challenging environments.

The locking nut on the AIR Speed Controller secures the needle position once you have set the desired flow rate. This prevents accidental adjustments during driving, ensuring consistent performance and stability.