72 ADAPTOR1/4X1/8MF

Boss recommends using a liquid thread sealant rather than thread tape. Small fragments of thread tape can break off, travel through the airlines and lodge in valves or valve blocks, causing them to stick open or closed. A quality thread sealant seals the threads without shedding debris.

Always cut the airline square with a sharp tube cutter, not side cutters. Push the tube firmly into the fitting until it bottoms out, then pull back gently to seat the collet. Most leaks are caused by angled cuts, scratched tube, or the line not being fully inserted.

You can often reuse fittings and lines if they are in good condition, but if the tube end is scratched, oval or has been repeatedly removed, it is safer to cut back to a fresh section or replace it. Damaged tube ends are a common source of slow leaks.

The 72 ADAPTOR1/4X1/8MF is designed to connect various components in your air suspension system, ensuring a reliable and efficient flow of air. It is essential for integrating your air fittings with airbags and other system components.

This adaptor features a 1/4 inch male thread on one end and a 1/8 inch female thread on the other, allowing for versatile connections within your air suspension setup.

Yes, it is recommended to use a liquid thread sealant on the threaded connections of the 72 ADAPTOR1/4X1/8MF. This helps prevent leaks and ensures a secure fit, avoiding issues that can arise from using thread tape.

The 72 ADAPTOR1/4X1/8MF is commonly used in air suspension setups for vehicles, trailers, and caravans. It is ideal for connecting air lines to airbags, compressors, and control valves, facilitating efficient air management.