3/8 Push Fit T Piece

Boss recommends using a liquid thread sealant rather than thread tape. Small fragments of thread tape can break off, travel through the airlines and lodge in valves or valve blocks, causing them to stick open or closed. A quality thread sealant seals the threads without shedding debris.

Always cut the airline square with a sharp tube cutter, not side cutters. Push the tube firmly into the fitting until it bottoms out, then pull back gently to seat the collet. Most leaks are caused by angled cuts, scratched tube, or the line not being fully inserted.

You can often reuse fittings and lines if they are in good condition, but if the tube end is scratched, oval or has been repeatedly removed, it is safer to cut back to a fresh section or replace it. Damaged tube ends are a common source of slow leaks.

The 3/8 PUSH FIT T PIECE is designed to facilitate the connection of multiple air lines in your air suspension system. It allows for efficient air distribution to airbags, ensuring balanced inflation and optimal performance of your Load Assist setup.

This fitting is specifically designed for use with Boss Air Suspension systems. While it may work with other brands, it is recommended to use Boss fittings for the best compatibility and performance.

The 3/8 PUSH FIT T PIECE is rated for high-pressure applications, ensuring it can handle the demands of air suspension systems. Always refer to the product specifications for exact pressure ratings and ensure your system operates within these limits.

No, the 3/8 PUSH FIT T PIECE should not be used to link airbags across the vehicle (left to right). It is intended for use in configurations that maintain separate air supply for each side, which is crucial for avoiding body roll and ensuring stability.

Installation of the 3/8 PUSH FIT T PIECE is straightforward. Simply cut the air lines squarely, push them into the fitting until they are fully seated, and ensure there are no leaks. Always check the connections after installation to confirm a secure fit.

The 3/8 PUSH FIT T PIECE is made from high-quality materials designed for durability and resistance to wear. This ensures long-lasting performance within your air suspension system, even under demanding conditions.

The 3/8 PUSH FIT T PIECE is commonly used in Load Assist kits for vehicles and trailers. It helps manage air distribution to airbags, enhancing load stability and ride quality, especially when towing or carrying heavy loads.