1/4 Tube x 1/4 NPT Elbow Fitting

Boss recommends using a liquid thread sealant rather than thread tape. Small fragments of thread tape can break off, travel through the airlines and lodge in valves or valve blocks, causing them to stick open or closed. A quality thread sealant seals the threads without shedding debris.

Always cut the airline square with a sharp tube cutter, not side cutters. Push the tube firmly into the fitting until it bottoms out, then pull back gently to seat the collet. Most leaks are caused by angled cuts, scratched tube, or the line not being fully inserted.

You can often reuse fittings and lines if they are in good condition, but if the tube end is scratched, oval or has been repeatedly removed, it is safer to cut back to a fresh section or replace it. Damaged tube ends are a common source of slow leaks.

The 1/4TUBE 1/4NPT ELBOW is designed to connect air lines in your air suspension system, allowing for efficient airflow and optimal performance. It is particularly useful in load assist setups where precise air distribution is necessary.

This elbow fitting is made from high-quality materials to ensure durability and resistance to wear. It is designed to withstand the pressures associated with air suspension systems, providing reliable performance over time.

The 1/4TUBE 1/4NPT ELBOW is specifically designed for use with Boss Air Suspension systems. While it may fit other systems that use 1/4 inch tubing and NPT threads, it is recommended to verify compatibility to ensure optimal performance.

This elbow fitting is commonly used in load assist kits for vehicles and trailers, providing a reliable connection point for air lines. It is ideal for setups that require precise air management for stability and load support.

Boss recommends using a liquid thread sealant instead of thread tape with the 1/4TUBE 1/4NPT ELBOW. Thread tape can fragment and cause blockages in the air lines, potentially leading to system failures.